The transmission line of the belt conveyor is adaptable and flexible. The length of the line can be customized according to needs. It can be as short as a few meters and can reach more than 10km in length. It can be installed in a small tunnel, or it can be erected above ground traffic chaos and dangerous areas. According to the requirements of the technological process, the belt conveyor can receive materials from one or more points very flexibly. It can also discharge to multiple points or several sections. When feeding materials to the conveyor belt at several points at the same time (such as the conveyor under the coal bunker of a coal preparation plant) or feeding materials to the conveyor belt through a uniform feeding device at any point along the length of the linear belt conveyor, the belt conveyor The machine becomes a main conveying trunk line.
In order to improve the conveying efficiency, the belt conveyor belt adopts the structure of sidewall belt. In the lifting height, in order to reduce the length and floor space of the belt machine, increase the inclination angle of the belt machine, and set up transverse partitions on the belt to prevent the material from falling. The main features of this new type of large-incline conveyor with ribs.
1 The structure is simple, and its transmission form is the same as that of an ordinary belt conveyor, except that the flat belt is equipped with wave-shaped ribs on both sides and partitions in the middle;
2 High conveying efficiency, increase conveying capacity on the same bandwidth, and prevent materials from falling and falling;
3 The material can be lifted at a large inclination angle, the captain can be shortened, and the floor space of the equipment can be reduced;
4 Product standardization and serialization can be realized, and common parts are common to ordinary belt conveyors;
5 The ribs and partitions are easy to install and easy to replace and repair.
The belt conveyor assembly line runs reliably. In many important production units that need to continuously transport materials, such as the transportation of coal in power plants, the transportation of bulk materials in iron and steel plants and cement plants, linear belt assembly lines are used. If the material transportation is unexpectedly interrupted on these occasions, the loss is huge. When necessary, the belt conveyor assembly line can work continuously one after another.
The belt conveyor has low power consumption. Since the material and the conveyor belt have almost no relative movement, not only the running resistance is small (about 1/3-1/5 of the scraper conveyor), but also the wear and breakage of the cargo are small, and the productivity is high. These are all conducive to reducing production costs.
The transmission line of the belt conveyor assembly line is adaptable and flexible. The length of the line depends on the need. It can be as short as a few meters and can reach more than 10km in length. It can be installed in a small tunnel, or it can be erected above ground traffic chaos and dangerous areas.
According to the requirements of the belt conveyor process, the belt conveyor assembly line can flexibly receive materials from one or more points or discharge materials to multiple points or several sections. When feeding material to the conveyor belt at several points at the same time (such as the conveyor under the coal bunker of the coal preparation plant) or feeding the conveyor belt through the uniform feeding device at any point along the length of the linear belt assembly line, the belt conveyor The assembly line becomes a major transmission trunk line.
The belt conveyor assembly line can take materials in the roadway below the stockpiles of the coal storage yard, and can also mix different materials from each pile when needed. The material can be simply discharged from the conveyor head, or it can be discharged at any point along the length of the conveyor belt through a plough unloader or a mobile unloader.